Crestron DM-NAX-AMP-X300 X-Series 300 W Flexible Output Amplifier

It is a DM NAX X-Series flexible output amplifier rated at 300 W. It takes DM NAX, Dante, AES67 and local analogue inputs, all with full DSP, and its four channels can be configured for low impedance speakers or 70V and 100V distributed lines, for residential or commercial use.

The four channels can run as four outputs of up to 75 W, two of up to 150 W, one bridged output of up to 300 W, or two 75 W outputs plus one bridged 150 W output. Slide switches set channels 1 and 2 and channels 3 and 4 to stereo, summed or bridged.

Yes. An operations mode switch sets the amplifier for Lo-Z operation at 4 or 8 ohms, or Hi-Z operation at 70V or 100V. In Hi-Z mode it delivers up to 300 W with one channel driven or 150 W per channel with two, and a HI-Z LED shows when the mode is enabled.

Yes. The amplifier has a native Dante mode and is AES67 capable, and it connects directly to a managed network to route audio to or from DM NAX, DM NVX, AES67 or Dante devices. Matrix mixing lets any input, local or networked, be sent to any output.

It runs from 100 to 240 V AC through an IEC 60320 C14 inlet, with a removable cord included, and uses 75 W with all channels at 1/8 power into 8 ohms. The 1RU, half-rack width chassis supports surface and rack mounting and measures 44 mm high, 238 mm wide and 280 mm deep.

Crestron asks its dealers to give the price of the DM-NAX-AMP-X300 directly rather than publish it online. Add it to your quote list and we will send you a written quote, with delivery, and installation and programming if you need them.

Yes. 1Install is an authorised Crestron Elite Partner with offices in Skerries, Co. Dublin and Cork. We can supply the DM-NAX-AMP-X300 on its own, or install, set up and programme it as part of your system. Installation visits are €440 for 4 hours or €880 for a full day, plus VAT and travel.

Yes. Everything we supply is new, genuine Crestron with Crestron's standard warranty. If the DM-NAX-AMP-X300 develops a fault, contact us and we will handle the claim with Crestron. If we installed it, our workmanship is guaranteed for the lifetime of the system.

We order Crestron for each quote, so availability depends on Crestron's stock at the time. We check it before we quote and put the expected delivery date on your quote, so you know where you stand before you pay.

Yes. We supply Crestron to end users, with or without installation. Like most Crestron devices of this type, it needs setting up or programming before it works in a system, and we can quote for that too.