Crestron CLCI-1SW2EX 2-Channel In-Ceiling Switch, infiNET EX, 230VAC

It is a compact two-channel in-ceiling switch for 230VAC lighting loads. Each channel is controlled independently, the unit communicates with a Crestron control system over infiNET EX wireless, and it has a remote input so a standard light switch can control the load.

Each channel handles incandescent, tungsten-halogen, magnetic low-voltage, electronic low-voltage, fluorescent ballast, neon/cold cathode and motor loads. Crestron rates each channel at 500 VA and lists a maximum load per channel of 2AX (2A fluorescent).

Yes. It requires a Crestron wireless gateway, sold separately, to connect to the control system over infiNET EX. Range is 46 m (150 ft) indoors and 75 m (250 ft) outdoors to the gateway, and 30 m (100 ft) indoors between devices.

Yes. A standard momentary or maintained switch connects to the remote switch terminal and gives basic on and off control. The connected switch or the on-board button can also be used for setup, and green LEDs show when each channel is on.

The plastic surface-mount housing measures 41 mm high, 178 mm wide and 55 mm deep, slim enough to sit in the ceiling next to or near the light fitting. It is rated for 0 to 40°C and 10% to 90% relative humidity.

Crestron asks its dealers to give the price of the CLCI-1SW2EX directly rather than publish it online. Add it to your quote list and we will send you a written quote, with delivery, and installation and programming if you need them.

Yes. 1Install is an authorised Crestron Elite Partner with offices in Skerries, Co. Dublin and Cork. We can supply the CLCI-1SW2EX on its own, or install, set up and programme it as part of your system. Installation visits are €440 for 4 hours or €880 for a full day, plus VAT and travel.

Yes. Everything we supply is new, genuine Crestron with Crestron's standard warranty. If the CLCI-1SW2EX develops a fault, contact us and we will handle the claim with Crestron. If we installed it, our workmanship is guaranteed for the lifetime of the system.

We order Crestron for each quote, so availability depends on Crestron's stock at the time. We check it before we quote and put the expected delivery date on your quote, so you know where you stand before you pay.

Yes. We supply Crestron to end users, with or without installation. Like most Crestron devices of this type, it needs setting up or programming before it works in a system, and we can quote for that too.