Crestron CLCI-1DIMFLV2EX Wireless In-Ceiling 2-Channel 0-10V Dimmer

It is a two-channel 0-10V dimmer that controls two independent 230VAC lighting loads. The ultra-slim unit fits in the ceiling on or near the light fitting and communicates with a Crestron control system wirelessly using infiNET EX.

Crestron lists a maximum load capacity of 500 VA per channel, with two independently controlled zone outputs. The dimmer controls 230VAC lighting loads using 0-10V dimming, so check that the light fittings accept a 0-10V control signal.

Yes. It has built-in support for a standard momentary or maintained switch. A standard light switch gives basic on and off control, and a momentary pushbutton can be used where the load needs dimming. The connected switch can also be used for setup.

It joins the Crestron system over infiNET EX wireless, after which it can be controlled from any keypad, touch panel, remote or mobile device. Occupancy sensors and photocells can be tied in with Crestron Fusion RV software to manage room assets.

Yes. Crestron describes it as a compact 2-channel dimmer for new or retrofit applications. It needs no special wiring and communicates wirelessly using infiNET EX, so no separate control cabling is needed back to the control system.

Crestron asks its dealers to give the price of the CLCI-1DIMFLV2EX directly rather than publish it online. Add it to your quote list and we will send you a written quote, with delivery, and installation and programming if you need them.

Yes. 1Install is an authorised Crestron Elite Partner with offices in Skerries, Co. Dublin and Cork. We can supply the CLCI-1DIMFLV2EX on its own, or install, set up and programme it as part of your system. Installation visits are €440 for 4 hours or €880 for a full day, plus VAT and travel.

Yes. Everything we supply is new, genuine Crestron with Crestron's standard warranty. If the CLCI-1DIMFLV2EX develops a fault, contact us and we will handle the claim with Crestron. If we installed it, our workmanship is guaranteed for the lifetime of the system.

We order Crestron for each quote, so availability depends on Crestron's stock at the time. We check it before we quote and put the expected delivery date on your quote, so you know where you stand before you pay.

Yes. We supply Crestron to end users, with or without installation. Like most Crestron devices of this type, it needs setting up or programming before it works in a system, and we can quote for that too.