Crestron FT2A-UTK-PWS 24 VDC Power Supply for FT2 ELEC FlipTops

It is the power supply designed for Crestron's FT2 ELEC Series FlipTop. It provides a regulated 24 VDC output at 2.5 A from a 100-240 VAC, 50/60 Hz supply, and one is included with each FT2 ELEC Series FlipTop.

Crestron notes that a second supply may be purchased when a FlipTop uses more than one USB Rapid Charging Module (FT2A-CHGR-USBA/C), but not more than two. A FlipTop with a single charging module runs from the one supply that is included.

It attaches beneath the table to mounting slots on the front, left or right side of the FlipTop chassis, using the mounting bracket that comes with it. The black plastic unit measures 125 mm high, 57 mm wide and 40 mm deep.

Mains power enters through an IEC 60320 C7 inlet, which mates with the removable power cord included. The 24 VDC output is on an attached 1.83 m (6 ft) cable with a 2.1 x 5.5 mm DC barrel connector, centre pin positive.

No. Crestron specifies it for indoor use only, with an operating temperature of 0° to 45° C (32° to 113° F) and humidity of 10% to 90% RH, non-condensing. It is designed to sit beneath the table, attached to the FlipTop chassis.

Crestron asks its dealers to give the price of the FT2A-UTK-PWS directly rather than publish it online. Add it to your quote list and we will send you a written quote, with delivery, and installation and programming if you need them.

Yes. 1Install is an authorised Crestron Elite Partner with offices in Skerries, Co. Dublin and Cork. We can supply the FT2A-UTK-PWS on its own, or install, set up and programme it as part of your system. Installation visits are €440 for 4 hours or €880 for a full day, plus VAT and travel.

Yes. Everything we supply is new, genuine Crestron with Crestron's standard warranty. If the FT2A-UTK-PWS develops a fault, contact us and we will handle the claim with Crestron. If we installed it, our workmanship is guaranteed for the lifetime of the system.

We order Crestron for each quote, so availability depends on Crestron's stock at the time. We check it before we quote and put the expected delivery date on your quote, so you know where you stand before you pay.

Yes. We supply Crestron to end users, with or without installation. If you are not sure it suits your system, send us the part numbers you already have and we will check.